NDP120
Neural Decision Processor
Always-on Speech & Sensor-Fusion Processor
The Syntiant® NDP120 Neural Decision Processor™ is a special purpose chip for audio and sensor processing for always-on applications in battery powered devices and other power constrained systems. The NDP120 applies neural processing to run multiple applications simultaneously with minimal power consumption. Built using the Syntiant Core 2™ programmable deep learning architecture, NDP120 is designed to natively run multiple Deep Neural Networks (DNN) on a variety of architectures, such as CNN, RNN and fully connected networks. NDP120 brings a level of ML performance that delivers 25x the tensor throughput compared to the Syntiant Core 1™ embedded in Syntiant’s NDP100 and NDP101 devices. A programmable HiFi 3 DSP is available for classical audio processing.
The NDP120 supports dozens of application-defined audio sequences for a variety of use cases including:
- Far-field, near-field and close-talk voice interface
- Multiple wake words and local commands
- Acoustic Echo Cancellation (AEC), noise suppression, beamforming
- Speech enhancement
- Speaker identification and verification
- Acoustic event and scene classification
- Multi-sensor fusion
BLOCK DIAGRAM

KEY FEATURES & BENEFITS
- Hardware acceleration support for up to 6.4 GOPS/s
- Neural network layers supported: fully-connected, 2D convolution, depth-wise convolution, recurrent neural network including LSTM and GRU, average and max pooling
- Support for concurrent neural networks
- Up to 896k neural parameters in 8-bit mode, 1.8M parameters in 4-bit mode, and more than 7M parameters in 1-bit mode
- Quad PDM digital microphone interface
- Dual I2S channels or TDM4 streaming interfaces
- Support for up to 7 audio streams including I2S/ TDM output audio interface for streaming audio output, including post-processed audio
- I2C controller and target modes for sensor control and integration
- QSPI target & controller interfaces
- 26 GPIO pins
- Programmable HiFi 3 DSP
- Input holding-tank with up to 10 seconds of audio recording and faster-then-real-time extraction
- Up to 100MHz internal operating frequency
- Embedded Arm Cortex-M0 for device management with 48KB SRAM, dual timers and UART functionality
- Low power PLL for flexible clock input
- Onboard firmware decryption and authentication
- Software Development Kit (SDK) integrates in any software environment
- Training Development Kit (TDK) to enable the use of standard frameworks such as TensorFlow for customer-programmed applications
- 3.1mm x 2.5mm 42-ball WLBGA package (0.4mm pitch)
- 5mm x 5mm 40-pin QFN package (0.4mm pitch) - also available as an AEC-Q100 Grade 3 qualified automotive SKU
APPLICATIONS
Connect the real world to the digital world with our cost-saving, next-generation edge AI interface that greatly improves the user’s experience by bringing speech, vision, and sensor processing to your device.

Mobile Phones

Earbuds & Hearing Aids

Personal Computers

Smart Home

IOT Endpoints

AR / VR HMDs

Media Streamers
